Proper maintenance of tugs
自上料攪拌車在每天運轉前，駕駛員需要對拖輪進行注油，另外每隔3個月的時間就需要對拖輪進行潤滑脂的補加。
The driver needs to inject oil into the tug before the feeding mixer runs every day. In addition, the tug needs to be lubricated every three months.
注意柱塞的行程余量
Pay attention to the stroke allowance of plunger
維修調試噴油泵時，需要對自上料攪拌車行程余量進行檢查，以此判斷噴油泵是否需要進行調整，將柱塞與套筒的磨損降到較低，駕駛員得要根據噴油泵的不同結構采用不同方法進行檢查。
When repairing and debugging the fuel injection pump, it is necessary to check the travel allowance of the self feeding mixer first, so as to judge whether the fuel injection pump needs to be adjusted, so as to reduce the wear of the plunger and sleeve to a low level. The driver has to use different methods to check according to the different structure of the fuel injection pump.
恰當保養散熱器
Proper maintenance of radiator
自上料攪拌車使用時長達3個月后，需要更換與原裝濾芯精度一致的濾芯，更換過后，每隔半年進行一次更換即可。此外，自上料攪拌車駕駛員應當每天對散熱器的風扇進行檢查，看其是否正常運轉。
Since the feeding mixer has been used for 3 months, the filter element with the same accuracy as the original filter element needs to be replaced. After the first replacement, it can be replaced every six months. In addition, the driver of self loading mixer should check the fan of radiator every day to see if it works normally.
機油不能只靠加，要換
You can't just add oil, you have to change it
機油具有潤滑、冷卻、情節等系列功能，在自上料攪拌車使用500小時候需要換油，換油后，每1500小時換一次油，值得注意的是，在換油時需要徹底清洗油道，避免機械雜質留在油底殼及油路中。
The engine oil has a series of functions, such as lubrication, cooling, cleaning and so on. When the self loading mixer is used for 500 hours for the first time, it needs to change the oil. After the first oil change, it needs to change the oil every 1500 hours. It is worth noting that when changing the oil, it needs to thoroughly clean the oil passage to avoid mechanical impurities remaining in the oil pan and oil circuit.
不能混合使用不同企業的液壓油
Do not mix different brands of hydraulic oil
自上料攪拌車使用時長達3個月時，同樣需要更換，不同企業的液壓油不能混合使用，更換液壓油時，油管、油管接頭、散熱器、液壓泵、液壓馬達需要清洗干凈，避免造成液壓馬達、液壓泵使用故障，延長壽命。換油過后，每年進行一次液壓油的更換即可。
Since the feeding mixer has been used for 3 months, it also needs to be replaced. Different brands of hydraulic oil can not be mixed. When replacing the hydraulic oil, the oil pipe, oil pipe joint, radiator, hydraulic pump and hydraulic motor need to be cleaned to avoid the failure of hydraulic motor and hydraulic pump and prolong the service life. After the first oil change, replace the hydraulic oil once a year.
